FLA Orthopedics Bathguard Lower Extremity Cast Protector for Legs

More Information

• Instructions for Use:
  - Gently slide over cast or bandage by pulling on the corners.
  - As the cast protector goes in water, air will rise to the top.
  - Before submerging, to achieve a watertight seal, pull it away from skin to release the air inside.
• Caution:
  - As wet plastic is slippery, please use caution around showers, baths, or other wet surfaces.
  - To help prevent slips and fall, leg models include non-skid pads on the foot piece.
  

Customer Reviews

Questions & Answers

Ask a Question

Enter your question below:

 

Security question 4+ 2 =   SubmitCancel

Enter your Answer below.

Security Question:4 + 2 =

	ItemQuestion ItemName - now
	Your question will show here once it will get approved.

	UserAnswer UserName - now Your Answer will show here once it will get approved.

How to put half leg cast protector on Carolyn - 11/23/2016 2:30:49 PM

ReplyShare

	Stretch the opening to enable sliding over your leg and when you lower your leg in water part way air inside is push to the top, for this hold FLA Orthopedics Bathguard Lower Extremity Cast Protector corners to release the air then the plastic shrinks on to your leg giving the effect similar to vacuum seal. Customer Care - 12/2/2016 4:42:02 AM

Opening looks too small. How to put on? Carolyn Nichols - 11/23/2016 2:15:17 PM

ReplyShare

	You have to stretch FLA Orthopedics Bathguard Lower Extremity Cast Protector to enable sliding over your leg. After sliding, you can seal tightly at the opening Customer Care - 12/2/2016 4:45:46 AM