Joint Jack Finger Splint

Name: Joint Jack Finger Splint
Brand: MISCELLANEOUS
SKU: 14366
Price: 76.9899978637695 USD
Availability: InStock

Brand/Manufacturer: MISCELLANEOUS

FSA Approved

Joint Jack Finger Splint helps correct PIP finger flexion contractures. By turning the screw, the pressure can be changed quickly. For perfect fit, a soft steel splint can be bent. It comes with a cotton strap that can be adjusted and a felt pad. The MCP crease at the base of the finger and the centre of the nail bed should be measured to determine size. Devoid of latex.

Item #	Desc	Pkg	Price
NC15382	Small, 1-1/2" to 2-1/2" (3.8cm to 6.4cm)	Each	$104.55 $76.99
NC15383	Medium, 2" to 3" (5.1cm to 7.6cm)	Each	$104.55 $76.99
NC15384	Large, 3" to 4" (7.6cm to 10cm)	Each	$89.90 $66.63
NC15385	X-Large, 3-1/2" to 4-1/2" (8.9cm to 11cm)	Each	$104.55 $76.99
NC15386	XX-Large, 4" (10cm) and Over	Each	$104.55 $76.99

Features of Joint Jack PIP Joint Splint

Made of mild steel for adaptation to all finger positions
The drive mechanism consists of a screw and strap permanently attached
Includes felt pad and cotton strap for additional comfort

When to use Finger Splint?

Dupuytren’s contracture post-surgery or Xiaflex
PIP joint stiffness
Trigger finger release (stenosing tenosynovitis or STS)

What to buy with Finger Joint Splint

How to apply Joint Jack PIP Finger Flexion Contracture Splint?

Bend the metal extension bar of the splint so the strap and screw fit directly at the PIP joint. Be sure the screw is directly perpendicular (at a 90º angle) to the metal plate.
Adjust the ends with pliers for a comfortable/contoured fit in the palm and to avoid pressure at the tip. The pressure should be more on the volar plate of the DIP joint than on the tip of the finger.
With the screw backed out, tighten the strap. A pen mark can be used to establish a consistent starting point.
Gradually tighten the screw, so there is steady pressure, not pain. There is rapid, early gain that must be overcome for each application. Because of this "rapid gain phase," the successful use of the Joint Jack® follows applications of one hour or more. During the course of the hour, continue to tighten the screw to maintain steady pressure gradually. Be careful not to tighten the screw too aggressively, which may cause pain.
Should the screw become fully tightened, it is backed off completely, the strap is taken up as much as possible, and the screw turning is resumed.

Customer Reviews

Please enter your and your friends email address below.

Fields marked with * are compulsory


Your Name: *	Error msg
Your Email Address: *	Error email
Friend's Name: *	Error fname
Friend's Email Address: *	Error remail
Message:
Captcha:	Hcaptcha Gcaptcha
	Submit Cancel