Skil-Care BedPro Safety Alarm Control Unit with Accessories

Name: Skil-Care BedPro Safety Alarm Control Unit with Accessories
Brand: SKIL CARE CORP
SKU: 20772
Price: 247.601699829102 USD
Availability: InStock

Brand/Manufacturer: SKIL CARE CORP

FSA Approved

Skil-Care BedPro Safety Alarm Control Unit protects patients against fall related injuries resulting from unassisted bed exists. It is designed without an on and off switch. Whenever the alarm is initiated, pressing the Auto-Reset button on top of the alarm unit will silence it. Pressing this button puts the system into the stand-by mode.

Size Chart

Item #	Desc	Pkg	Price	Price
909335	BedPro Safety Alarm	Each	$334.21 $247.60

Features

Skil-Care BedPro Safety Alarm Control Unit includes:
- Nurse-call connector
- A/C adaptor
- Battery
System will automatically go into the monitoring mode when you put your patient to bed
No need to remember to turn the system on
Features auto reset, auxiliary connector, in-room on-off and indicator light
Battery test, low battery indicator and high-low volume
Two buzzer or two music tones
Cable strain relief and protective bumpers
Headboard mounting bracket
Also available:
- Skil-Care Replacement Sensor Pads for BedPro and MultiPro Alarm Units (Code # 909314)

More Information

How to Use:
- Press Power Test button before putting patient to bed. If In-Room Alarm switch is set to the On position, the alarm signal will sound and the LED will glow while the button is held down. If the IN-Room switch is set to the Off position, the LED will glow while the button is held down. If the LED and/or alarm signal are not activated when button is pressed, check power source connections. If alarm is on battery power, replace 9-volt battery. Do not use alarm system if pressing Power Test button cannot activate LED and/or alarm signal.
- Place patient in bed. The LED should glow indicating that the alarm is in the monitoring mode. If LED does not glow, remove patient from bed and examine sensor pad. If pad is damaged, replace it. Do not use alarm system if LED does not glow when patient is in bed.
- If alarm is set to signal both at bedside and at the nurses station, select alarm volume by moving the volume selectro switch to High or Low.
- If your patient leaves the bed and then returns, the alarm will silence and the system will reset itself. Be certain to visit the patient to make sure he/she is safe.
- Press teh Auto-Reset button after you have removed your patient from bed. This will place the system in the stand-by mode.

Warranty

6 Months warranty

Customer Reviews

Please enter your and your friends email address below.

Fields marked with * are compulsory


Your Name: *	Error msg
Your Email Address: *	Error email
Friend's Name: *	Error fname
Friend's Email Address: *	Error remail
Message:
Captcha:	Hcaptcha Gcaptcha
	Submit Cancel