R&B Wire Linen Carts

R&B Wire Linen Carts

Brand/Manufacturer: R&B WIRE PRODUCTS INC
Authorized Retailer Badge

R&B Wire Linen Carts are bright shiny chrome plated carts which are as versatile as practical. The shelves have full shelf length center supports for outstanding strength. When used in conjunction with flame retardant 200 denier urethane coated nylon cover and plastic insert for the bottom shelf you can transport this unit in any healthcare environment.


  • R&B Wire Linen Carts are easy to assemble without tools
  • Roll easily on two 5" locking casters
  • Casters are rated for a maximum total weight of 1,000lbs per unit (250lbs each)
  • Shelves are adjustable in 1" increments
  • Each shelf can hold up to 500 lbs of evenly distributed weight
  • Covers available for all size units

More Information

  • Assembly Instructions:
    -Each of the 4 upright poles has 2 parts, a top and a bottom piece. The top pieces have black caps. The bottom pieces have leveling feet and a threaded pole connector already installed. When building the Linen Cart, unscrew the leveling feet and remove them from the poles. While holding the bottom pole upside down slip a caster into the end of the pole, where the leveling foot was removed. Tap the pole with the caster lightly on the ground. This will cause the caster to slip into the pole and lock into place. Do not tap the pole too hard on the ground as this may cause damage to the threaded connector
    -Take the 4 bottom poles, the 2 piece, black plastic "slipsleeves" and one of the shelves. Place the plastic "slipsleeves" onto the pole at the desired height of the bottom shelf. The sleeves will slide up and down the pole until they snap into one of the circular grooves along the poles. The shelf will not set properly if all the "slipsleeves" are not at the same level. The wire surface should be on the top of the shelf
    -With the shelf lying on its side, insert the four legs through the holes of the shelf. After inserting all four legs, take the shelf and poles and stand upright
    -Add four more of the plastic "slipsleeves" slip shelf onto poles until the shelf rests on the "slipsleeves"
    -Take the top halves of the poles and screw onto the bottom halves that already have the shelves in place. Repeat step 4 until all the shelves are in the desired locations
  • Caution:
    -Do not stand or climb on the system
    -Do not drop heavy items on the system shelves
    -Keep center of gravity low place heavier items on lower shelves
    -Roll with caution. 2 people recommended to operate

Customer Reviews

Please enter your and your friends email address below.
Fields marked with * are compulsory

Submit Cancel
The selected product information has been successfully emailed to your friend.

Thank you for using www.rehab-store.com