Moen SecureMount Anchor System

More Information

• Installation Instructions:
  Direction for wall mounting installation:
  - Position grab bar on wall in desired location and mark around the outside of the flanges
  - One at a time, center the mounting plate within the marked flanges, and mark the center hole for drilling
  - Drill one hole at each mounting location
  - Insert guide sleeves into each hole in the wall. (Note: UP indicator must always point up regardless of grab bar orientation)
  - Connect pull tab to the secure mount anchor
  - With pull tab up, insert the anchor all the way into the hole in the wall
  - Pull back on the pull tab, and disconnect it from the anchor
  - Place mounting plate over the hole and secure with the anchor screw, and flat and rubber washers. (Note: Bar indicators should be facing in, align arrows) - Align the grab bar flanges to the secure mount anchor and secure with flange screws and split lock washer
  Directions for stud mounting installation:
  - Position grab bar on wall in desired location and mark around the outside of the flanges
  - Determine stud center and drill one pilot hole at each location.
  - Install wood screw supplied with grab bar
  - Install the 3 additional wood screws through the grab bar flange into the elongated mounting plate slots
  

Customer Reviews