Maddak Autodrop Eye Drop Guide

More Information

• Instructions
  - Open Autodrop
  - Loosen cap from bottle, but do not remove completely
  - Place the keyhole slot around the base of the bottle neck
  - Close the Autodrop
  - Do not force the bottle nose into Autodrop, it should close easily
  - Hold down lower eyelid. Place Autodrop over the eye with the lip of the Autodrop against the cheek
  - Tilt head backwards looks through pin-hole towards the light
  - Squeeze bottle gently to allow prescribed drops to fall into the eye
  - Open Autodrop and replace top on eye drop bottle
  - To clean Autodrop remove eye drop bottle and wash autodrop in warm soapy water
  - Rinse and dry thoroughly
  - When an eye drop bottle is discarded remove Autodropand clean thoroughly before fitting to the new bottle
  - It may be used on more than one type of eye drop at the same time but if you suffer from more than one eye complaint we recommend that you use a separate Autodrop for each type of eye drop
  - For clinics and hospitals: It may be autoclaved on a low pressure cycle for 30 minutes. Release clip to allow moisture to evaporate. It can also be cleaned in sterilizing fluid. Rinse and dry thoroughly

Warranty

12 months parts and labor

Customer Reviews