Klip Lightweight 4-Wheeled Posterior Walker With Seat

How to use Klip Lightweight Posterior Walker?

• Unfold Walker: Grasp front and rear legs and pull away from each other. Continue to unfold the frame until the latch push pins snap into place and fully protrude from the hole. 
• Assembly: Match numbered markings on leg with frame, press in the pushpins and slide into the leg frame. 
• Height Adjustment: To determine the correct height for the walker, the length measured from the Introduction Genral Use crease of wrist-to-floor should be the handle height. To adjust height, press the push pin on each leg and slide the leg to the proper position. Always check that all 4 legs are the same height and that the push pins fully protrude from the holes. 
• Lock/Unlock Swivel Wheels: Press down on the green lever to lock wheel and lift to unlock. Make sure that wheel clicks into place when locking the wheel. 
• One-directional Rear Wheels: To disengage directional lock, raise aluminum pin and place into override bracket. 
• Anterior/posterior Setup: Front and rear legs can be interchanged to switch from posterior to anterior use for all walkers other than KP210R, KP410R, and KP510R. 
• Fold Walker: Face walker from the open end, raise front wheels so that walker is resting on rear wheels/legs, press in latch push pins and push front legs towards rear legs. 
• Seat: Flip up seat when standing and walking. Fold down seat for sitting and resting. When folding walker, seat must be raised.

Maintenance And Care

• Inspect walker by checking all screws, nuts and bolts regularly.
• Keep walker clean to ensure longevity and comfort while using it.
• Mix warm water with a mild detergent and gently scrub your walker. Wipe clean with a dry soft cloth.

Specification

Warranty

3 Year Limited Warranty

Customer Reviews