Invacare 9000 XT Recliner Wheelchair

More Information

• Unfolding the Wheelchair:
  1. Tilt the wheelchair towards you (raising the opposite wheel and caster off the ground/floor).
  2. Place your hand on the top of the seat rail closest to you where the seat upholstery is attached.
  3. Point your fingers and thumb to the inside of the wheelchair.
  4. Press downward on the top of the seat rail until the wheelchair is fully open and the seat rails are fully seated in the H-blocks.
  5. Engage both wheel locks, open the footrest/legrest for clearance and transfer into the wheelchair.
• Folding the Wheelchair:
  1. Swing footrest/legrest in locked position to the front of the wheelchair.
  2. Pivot footplates upward to vertical position.
  3. From behind the wheelchair, grasp the right hand edge of the solid seat.
  4. Raise the seat to the hinged side.
  5. With both hands, grasp the middle of the front and back edges of the solid folding seat and lift up until the wheelchair begins to close.
  7. Continue to close the wheelchair by grasping the armrest furthest from you and pulling the armrest towards you.
• Operating Invacare 9000 XT Recliner:
  1. Unfold wheelchair.
  2. Attach spreader bar.
  3. Adjust the tightness of the headrest/back upholstery.
  4. Make sure wheelchair is occupied and on a level surface before reclining.
  5. Engage the wheel locks.
  6. Inform the occupant of the wheelchair that the wheelchair is about to be reclined.
  7. Make sure occupant hands and body are clear of all pinch points.
  8. Stand behind the wheelchair and grasp both push handles firmly.
  9. Squeeze release handles.
  10. Slowly pull back on the back assembly while squeezing the release handles.
  11. When the back reaches the desired angle, slowly let go of the release handles.
  12. To return the back to the full upright position, reverse Steps 8-11 keeping in mind proper body mechanics.
• Cleaning Metal Surfaces:
  - Hot water and a mild detergent on soft cloth should be used for cleaning metal surfaces
  - Wipe down with damp cloth
  - Dry surface by wiping down with dry cloth
  - Car polish and soft wax can be used to remove abrasions and restore gloss

Specification

Warranty

5 year limited warranty

Customer Reviews