Graham Field Everest and Jennings Traveler L3 Plus Wheelchair

More About Graham Field L3 Plus Whee

Important Safety Precautions:

• When the wheelchair is in use, anti-tippers must be installed in the downward position.
• Indicates a potential hazard situation or unsafe practice that, if not avoided, could result in death or serious personal injury.
• Indicates a potential hazard situation or unsafe practice that, if not avoided, could result in minor or moderate personal injury.
• NOTICE: Indicates a potential hazard situation or unsafe practice that, if not avoided, could result in product or property damage.
   

Warnings

• Traveler L3 Plus maximum weight capacity is 300 lb (136 kg), EVENLY DISTRIBUTED.
• Do not operate this wheelchair on streets or roadways.
• Do not operate this wheelchair on hilly or rough terrain, sand, wet or icy surfaces, or surfaces with impaired traction. Ensure that pathway is clear of all obstacles.
• Do not turn wheelchair while going downhill, as wheelchair could tip over.
• Do not attempt inclines without antitippers installed in the downward position. Do not attempt any incline or decline greater than six degrees (10% grade, or one foot of rise or fall per ten feet of ramp length).
• This wheelchair does not offer seating or occupant restraint equivalent to the seat provided in a motor vehicle! To increase your safety while traveling in a motor vehicle, always transfer to the vehicle seat and use the restraint provided by the vehicle manufacturer.
• Do not tie down or attach anything to the wheels. This could cause tipping and possibly result in injury or damage to the wheelchair.
• The footplates; lowest point should clear the ground by at least 2 1/2 inches, to permit proper clearance of potential obstruction.
• Doing a wheelie‚¬ (tilting the wheelchair backward until it reaches its balance point) is dangerous and could result in personal injury to the user.
• Do not stand or step on the footplates while transferring to or from your wheelchair. This could cause the wheelchair to tip or may cause personal injury or damage to your wheelchair.
• Do not place your hands between seat rail and side panel. WARNING: Always engage wheel locks before transferring, using a wheelchair lift or using an elevator.
• Ensure that wheelchair is on a stable, level surface and engage wheel locks before and during transfer.
• Operate only with anti-tippers in place when leaning or tipping. When wheelchair is in use, anti-tippers must be installed in the downward position.
• Do not lean over the top of the wheelchair back. This could cause the wheelchair to tip over.
• To reduce the risk of tipping before leaning or reaching forward, sit back in the seat and rotate casters fully toward front of wheelchair.
• Unauthorized modification or the use of non-Everest & Jennings replacement parts could change the structure of the wheelchair, void the warranty, and create a hazardous condition resulting in serious personal injury.
• Do not lean on this wheelchair or use it as a walker‚¬these are practices which could result in loss of balance and personal injury.
• Do not use your wheelchair on escalators.
• Wheel locks are not brakes. Do not use the wheel locks to slow down your wheelchair, or while the wheelchair is moving. Wheel locks are only intended to keep the wheelchair in place when it is at a complete stop.
• Notice for California CustomersCalifornia Proposition 65 WARNING: This product contains a chemical known to the State of California to cause cancer and reproductive or developmental harm.
• GF Health Products, Inc. specifically disclaims responsibility for any personal injury or property damage which may occur during any use which does not comply with federal, state, or local laws or ordinances.
   

Transfer Activities: 

• Always ensure that the wheelchair is on a stable, level surface and engage wheel locks before transfer. 
• Do not step on the footplates; this could cause the wheelchair to tip. Fold them up, and either detach them, or swing them aside. 
• There is a critical moment when there is little or no seat platform beneath you. Take every precaution to reduce this unsupported distance before you attempt transfer.

Reaching / Bending

• Always turn the casters frontward to provide stability while reaching. If in doubt, ask for assistance or use a device that will extend your reach without requiring you to shift your weight.
   

Forward or sideward

• Do not attempt to reach objects if you are required to move forward in the seat. 
• Do not attempt to retrieve objects from the floor if you must reach down between your knees. 
• Do not shift your weight in the direction that you are reaching and/or bending; this could cause the wheelchair to tip.
   

Backward

• Do not engage the wheel locks while reaching or bending backward. Should your weight suddenly shift accidentally, it is better to roll in that direction than to tip over.
• Do not lean over the back upholstery; this could cause the wheelchair to tip.
   

Maintenance:

• Improper maintenance can cause operating problems and may affect your warranty.
• Unauthorized modification or the use of non-Everest & Jennings replacement parts could change the structure of the wheelchair, void the warranty, and create a hazardous condition resulting in serious personal injury.
   

Troubleshooting:

• A complete inspection of your wheelchair, including maintenance, servicing and safety checks, should be performed by a GF authorized distributor at least every six months.
• Unauthorized modification or the use of non-Everest & Jennings replacement parts could change the structure of the wheelchair, void the warranty, and create a hazardous condition, which could result in serious personal injury.

Specification

Warranty

Five (5) year limited warranty

Customer Reviews