Evac Chair 600H Evacuation Chair

How To Use Evac Chair 600H Evacuation Chair?

• While standing behind the Evac Chair, hold it upright and rest one foot on top of the blue base frame crossbar to steady the chair
• Using both hands, pull the handle upwards until the shoulder clips have clicked into place
• Head restraint should not slide down the handle
• While still standing behind the chair, undo the seat belt to release the skis
• Pull these skis towards you to open the seat and push the seat part way downwards into position
• Finally, pull up the seat frame against the ski to ensure it is in position

• You must remain in position behind the Evac Chair using both uprights of the handle to hold it firmly
• Place one foot on the front wheel axle or on the bottom bar as your occupant transfers into the Evac Chair seated position
• Depending on the condition of the occupant further assistance may be required with the transfer
• Seatbelt must now be fastened and the head restraint may be used to assist with airway management if required
• From the transfer position, remove your foot from the front wheel axle until the Evac Chair move backward and the front wheel comes into contact with the ground
• Evac Chair will now balance between the bar of the frame and the front wheels
• From the balance position, tip the chair off further seven centimeters backward that is about three inches and you will be able to move forward in the two-wheel position
• This is the position to use for traveling short distances such as when turning and crossing still landings during descent

• Evac Chair should be used in the four-wheel position like a wheelchair
• To achieve the four-wheel position start from the vertical upright position, place one foot on the trolley assembly just over the yellow sticker and pull back sharply to unclip the trolley assembly
• As you remove your foot, the trolley assembly will automatically open
• You may then lower the chair gently onto its wheels

• Close the trolley assembly in an appropriate area of safety by placing the Evac Chair in a vertically upright position with the bottom bar of the frame on the ground
• Place your foot on the yellow sticker and push the trolley assembly forward until it clicks back into place
• Tilt the chair back into the two-wheel position and move forward to approximately 30 centimeters from the top of the stairs
• Positioned at the inside edge, with one foot in front of the other and slightly apart, tilt the chair a little further back and push confidently over the top of the stairs
• At all times stay near the inside edge of the stairs and make certain the skis make contact with the top two stair nosings
• Never let go of the Evac Chair
• Pause briefly and reposition your hands by sliding them upwards from the vertical position at each side of the handle onto the handles horizontal top crossbar
• When descending, press downwards in a vertical direction for a smooth safe ride and move forward at the same smooth pace as the back chair
• There should be no bumping action

Evac Chair 600H Specification

Warranty

Lifetime Warranty

Customer Reviews