Drive Aluminum Transport Chair With Swing-Away Footrests

More Information

• Maintenance tips:
  - At least once a week, wipe off chrome using a clean soft cloth
  - If the chair is exposed to moisture, dry the chair immediately
  - The metal parts of the chair should be polished once a month with an auto wax
  - Clean the upholstery with a mild soap solution, rinse and wipe dry
  - Worn or torn upholstery should be replaced promptly as it may not support your body weight
  - Inspect the wheels at least once a month
  - Correct any side play by loosening the lock nut on the axle, then tighten the axle just enough to remove side play
  - Solid rubber tires require limited upkeep, but need to be cleaned periodically with a damp cloth
  - Solid rubber tires need to be replaced if they become cracked or severely worn
• Safety tips:
  - Before entering or leaving the chair, engage the dual wheel locks against the tires on both rear wheels
  - Make sure the front casters are in the forward position before transferring into or out of the chair
  - Do not move forward on the seat while leaning forward out of the chair
  - If it is absolutely necessary to do so, make sure the front casters are in the forward position
  - If you are picking an object up from the floor, go past the object and then go backwards
  - The casters will then swing to the forward position
  - Leaning out of the transport chair without proper assistance could cause tipping
  - Do not step on the foot plates when transferring, as this could cause tipping
• Operating Tips:
  - Your Transport Chair Dealer (Wheelchair rental Dealer) can assist you in making adjustments and provide you with operational information
  - To Open the chair, tilt to one side and push down on seat rails
  - Lift back support to upright position
  - The lock to secure the back will engage automatically
  - To fold down and store, pull up on locks simultaneously, and carefully fold down the back support
  - To attach footrests, align the holes on the footrest arm with the pegs on the frame of the Transport chair
  - To Adjust the length of the footrests, loosen the bolt (or knob) on the telescoping tube shaft
  - Tighten securely after adjustment
  - The lowest part of the footrest should not be less than 2 1/2 inches from the ground to permit proper clearance

 WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov
 

Specification

Warranty

Limited lifetime warranty

Customer Reviews