Breg ShortRunner Neoprene Knee Brace With Patella Stabilizer

What to Buy with Breg Patella Stabilizer Neoprene Knee brace?

• Polar Knee Pain Relief Kit
• Skillbuilders Positioning knee wedge
• Fabrication Point Relief HotSpot Warming Gel

How to Use ShortRunner Neoprene Knee Brace?

• The wrap-on brace is applied with the closures in the front of the leg and the kneecap cutout centered over the knee. Secure the closures firmly
• The slip-on brace is applied by pulling the brace on with the kneecap cutout centered over the knee
• Both the wrap-on and pull-on braces have tightening straps. The straps should be tightened firmly, starting with the two straps closest to the knee.
   

Adjustment Instructions:

• Polycentric hinge with stops:
  • Both flexion and extension stops are supplied with the brace.The brace comes with a 10° extension stop already installed. The stops are labeled in degrees as follows:
    • Extension Stops:0°, 10°, 20°, 30° & 40°
    • Flexion Stops:45°, 60°, 75° & 90°(no flexion stops are installed upon shipment)
  • To change the stops, first, completely remove the screw as shown. Then remove the stop. Insert the new stop, align with the holes in the hinge, then reinsert the screw.
  • Using a Phillips head screw driver, ensure that the screws are seated in the recess and completely tightened.
  • Both medial (inside) and lateral (outside) hinge stops must be identical in degree.
  • NOTE: Due to soft tissue compression, we recommend the use of extension stops at least 10° greater than the desired limit. (e.g., if you desire a 10° extension limit, use the 20° extension stop).
• Polycentric hinge with pins:
  • The hinge settings are labeled in degrees as follows:
    • Extension settings: 0°, 10°, 30°, 50°, 70°, 90° & 110°
    • Flexion settings: 0°, 10°, 30°, 50°, 70°, 90° & 110°
  • To change the settings, first, open the hinge cover.
  • Then, move the pins to the desired extension and/or flexion settings for both the upper and lower leg.
  • When satisfied, close the hinge cover. Both medial (inside) and lateral(outside) hinge settings must be identical in degree.
  • NOTE: Due to soft tissue compression, we recommend the use of extension stops at least 10° greater than the desired limit. (e.g., if you desire a 10° extension limit, use the 20°extension stop)
  • Breg ShortRunner Knee Brace Instruction Manual

How to Wash and Care Neoprene Knee Brace?

• After exposure to saltwater or dirt, thoroughly rinse the brace with freshwater and allow it to air dry
• A dry lubricant, such as Teflon spray, may be used on the hinge occasionally
• Do not use wet lubricants
• The hinge assemblies may be removed to allow easier washing of the sleeve and straps
• The sidebars may be bent to accommodate individual legs. Bend in equal amounts above and below the hinge
• Periodically inspect the sleeve, straps, and hinges for excessive wear
• Be sure all screws are tight and stop in place

Precautions for Using Breg Neoprene Knee Brace:

• For single patient use only
• If you experience increased pain, swelling, or any adverse reactions while using this product, immediately consult your medical professional
• This device will not prevent or reduce all injuries
• Proper rehabilitation and activity modification are also an essential part of a safe treatment program

Breg ShortRunner Neoprene Knee Brace Specifications

Customer Reviews