Medline Knockdown Shower Chair with Back

More Information

• Remove contents from the box making sure you have all parts described here
• Place the seat upside down on a flat surface
• Place the leg section marked with a “B” into the groove of the bottom of the seat marked “B”
• Place the leg section marked with an “A” on top of the “B” tube and into the groove of the seat marked “A”
• Insert the shorter thumb screw through the middle hole but do not fully tighten the screw
• Next, assemble the backrest by taking the “L” shaped backrest supports and securing them to the backrest using the shorter thumb screws
• Attach the backrest to the seat by aligning holes on “L” shaped frame supports with the holes on the leg section
• Secure the legs of the frame marked “B” in place by using the longer thumbs screws
• Make sure you  attach the backrest to the “rear” of the seat as marked on the bottom
• Secure the legs of the frame marked “A” in place with the remaining two longer thumb screws
• Fully tighten the shorter middle screw and check to make sure all screws are fully tightened
• Insert legs into the leg frame by depressing the pushbutton, sliding legs over the receptacle, and setting them to the desired height. Make sure all the legs are set to the same height

Adjusting Leg Height :

• Before using the seat, make sure all legs are set to the same preferred height
• To do so, depress the pushbutton and slide each leg to the desired height by aligning with proper holes and letting the pushbutton snap into the correct hole to lock the leg in place
•   Make sure legs are locked into place by pushing down and pulling up on each leg

Maintainance:

• Periodic visual inspection of this bath chair is recommended to ensure that all parts and hardware are secure, that components are in good working order and not worn, torn, frayed, or loose, and that there are no obstructions or impediments to normal, safe operation
•  If any part or mechanism appears to be unsafe or damaged, do not use the product

Caution:

• Inspect all parts for possible damage before assembling. If there is any damage - DO NOT USE. Contact dealer/carrier for further instructions
• Make sure that the height-adjusting pushbuttons fully extend through the same corresponding hole of each leg extension
• This ensures that the leg extensions are securely locked in place at an even height
• Make sure all screws, nuts, and/or bolts are tightened
•  Make sure the rubber tips are in place on the leg extensions and not ripped, worn, or missing. Replace any missing or damaged tips
• The rubber tips of all four leg extensions MUST touch the floor simultaneously at all times
• NEVER stand on chair

Care Instructions of Medline Knockdown Back Shower Chair:

• To maintain the appearance and promote good hygiene, clean periodically with mild soap
• Rinse with warm water
• Wipe the bath seat dry after each use

Medline Knockdown Shower Chair with Back Instruction Manual

Specification

Customer Reviews