Core CorFit Lumbosacral Support Belt

More On CorFit Lumbosacral Support Belt

Measurement:

• Measure True Waist.
• Snug Fit Measurement: Devices are sized at a compressed fit.
• Measuring loose vs skin tight can be 2-2 ½ inches.
• Hip Measurement: Measure at fullest part of the buttocks.
• Approx: Across the groin area in the front.
   

Fitting Instructions:

• Fitted starting in the back and finishing in the front.
• Support Should be centered on the back.
• Bottom of support should be at the crease of buttocks.
• Any straps should be below the breast line.
• Back of support should be at least 2"below the shoulder blade and front top edge should not compress on the bottom of the sternum (chest bone).
• Pull straps out away from body and then cross.
• Normally straps fit right over left.
• Add compression from bottom to top.
• Where you apply the external straps can have an effect on the location of compression.
   

Post Fitting Instructions:

• Sit down to check fitting that it does not dig into the groin.
• Body length will shorten when sitting so make sure the support is lined up properly.
• The support should not catch and dig under shoulder blade, irritate the breast line or dig into the groin area.
• When removing, decrease compression from top to bottom.
• When removing, disengage the Velcro straps and attach them at the posterior of the support near the strap origin.
• Depending on your condition, the application of the device may need to be done by a secondary care-taker or significant other. 
• You can obtain the best secure fitting if you are able to apply the support while laying down w/knees bent.
   

Care Instructions:

• Hand wash with cold water and a mild detergent
• Do not bleach
• Line/air dry
• Avoid direct heat