R&B Wire Shelving Units

More Information

• Assembly Instructions:
  - Each of the 4 upright poles has 2 parts, a top and a bottom piece. The top pieces have black caps. The bottom pieces have leveling feet and a threaded pole connector already installed. When building a shelving unit leave the leveling feet in place. They can be adjusted to level the unit after assembly is complete
  - Take the 4 bottom poles, the 2 piece, black plastic "slipsleeves" and one of the shelves. Place the plastic "slipsleeves" onto the pole at the desired height of the bottom shelf. The sleeves will slide up and down the pole until they snap into one of the circular grooves along the poles. The shelf will not set properly if all the "slipsleeves" are not at the same level. The wire surface should be on the top of the shelf
  - With the shelf lying on its side, insert the four legs through the holes of the shelf. After inserting all four legs, take the shelf and poles and stand upright
  - Add four more of the plastic "slipsleeves" slip shelf onto poles until the shelf rests on the "slipsleeves"
  - Take the top halves of the poles and screw onto the bottom halves that already have the shelves in place. Repeat step 4 until all the shelves are in the desired locations
• Caution:
  - Do not stand or climb on the system
  - Do not drop heavy items on the system shelves
  - Keep center of gravity low – place heavier items on lower shelves
  - 2 people recommended to operate

Customer Reviews