1-Switch Single-Appliance Unit

More Information

• Installation and Operating Instructions:
  - Set the frequency code on the white receiver to the letter A, which is located on the front of the unit
  - Insert two AA alkaline batteries in the transmitter’s battery compartment. Use alkaline batteries only (e.g. Duracell or Energizer brand)
  - Do not use rechargeable batteries or any other type of batteries because they supply lower voltage and the unit will not perform properly
  - Never mix old and new batteries together or different brands or types together.
  - Plug your capability switch into the jack on the transmitter
  - Check that the power switch on your appliance is On, and plug the appliance into the receiver module
  - Plug the receiver module into any (unswitched) AC wall outlet and raise the antenna(Note: the range of the remote module can be decreased by simply lowering the antenna)
  - Activate the remote transmitter unit using your capability switch
   
• Mode Settings:
  - Momentary Mode:
  • Turn the selector switch to the Momentary position. Device will turn on with sustained activation of your switch. Once the switch is released, the device will immediately turn off.
  - Latch Mode:
  • Turn the selector switch to the Latch position. Device will turn on with first switch activation and remain on until turned off by a second switch activation. Please Note: these operations will be accompanied by a small audible “click” produced from the receiver module. This is normal.

Customer Reviews