Lego Recording Communicators Pediatric Assistive Toys

How to use Lego Communicators?

1. The Communicator requires 3 AA batteries to operate (Not included). Gently turn the unit over to reveal the black battery compartment. Carefully remove the small screw from the battery compartment cover using a Phillips head screwdriver, and slide the battery compartment cover off. Observing polarity, install 3 AA size batteries into the holder. Alkaline batteries must be used only (e.g. Duracell or Energizer brand). Do not use rechargeable batteries or any other type of batteries because they supply lower voltage and the unit will not perform properly. Replace the battery compartment cover and screw.
2. Turn the unit on by turning the ON/OFF toggle switch to ON, located on the bottom of the unit.
3. To record, simply press and hold the red “RECORD” button on the back of the unit, while holding the ‘’RECORD’’ button, speak your message. Your mouth should be about 6 inches from the microphone when recording (the Microphone is the “fuzzy” black circle on the bottom of the unit). Release the record button when you finish recording. You have a maximum record time of 10 seconds total.
4. To play back your message, simply activate the plate switch. It is not necessary to continue holding the plate switch when listening to the message. The unit will continue to playback the entire message, even if pressure on the switch is released.
5. The unit will retain recorded information indefinitely, even if the batteries are disconnected. Previously stored information will be erased only when a new recording is performed.

Customer Reviews