Harmar Vehicle Wiring Harness

How to wire vehicle using Harmar Wiring Harness?

• Begin routing the wiring harness at the vehicle battery 
• Attach the black wire to the negative terminal on the battery 
• Do not attach the red wire until the end 
• Run the wiring harness under or when possible through the vehicle, back to the rear cargo area/trunk 
• Through the vehicle is best, gaining entry into the vehicle through the firewall 
• If wiring harness is under the vehicle, a hole will most likely need to be drilled to get the wire into the rear cargo area/trunk 
• Always locate the wiring where it cannot be snagged by road debris and away from the gas tank 
• If the harness is too long for the vehicle, coil the excess wire and secure it to the vehicle frame with supplied tie wraps 
• Once the harness is run into the vehicle, remove pins protective tubing Inspect the pins retaining flanges as it may have become deformed while running them through the vehicle 
• These are critical to secure the pins inside the end connector 
• Adjust as needed 
• Flip open end connectors hinged retainer
• The gauge of the wiring harness is a 12 gauge harness