DenTek Temparin Max Lost Filling and Loose Cap Repair Formula

How to use DenTek Temparin Max Lost Filling and Loose Cap Repair Formula?

• Wash the cavity area with warm water and do not dry. 
• Cut with spade tool or pinch a small amount of Temparin Max from the vial, and roll into a ball between fingers. 
• Slightly overfill the cavity with Temparin Max and tamp into place with applicator tool tip. 
• Close your teeth together, as if you were biting down on a piece of paper, and gently chew or grind on the replaced filling a couple times to create a comfortable bite. 
• Use a moist cotton swab to remove excess Temparin Max from around the area. Moisture will accelerate the set. 
• Temparin Max will set softly in your mouth within a few minutes, but avoid chewing on the repair for 2-3 hours to allow the material to fully set.

Directions to secure loose crowns, caps, or inlays:

• Try the crown, cap, or inlay first to see if you can fit it accurately back onto the tooth surface. 
• If user are not able to do so, or if remaining tooth is cracked, then do not proceed further. 
• If the crown has a post attached to it or if there is tooth surface remaining inside the crown, Temparin Max may not adhere. 
• Carefully rinse the tooth area and the inside of the crown, cap, or inlay with warm water, and do not dry. 
• Cut with spade tool or pinch a small amount of Temparin Max from the vial, roll into a ball between fingers, and place evenly inside the crown, cap, or inlay. 
• Place the crown, cap, or inlay on the tooth and bite down, applying pressure to push into position. 
• Temparin Max will begin to harden within a few minutes, but avoid chewing on the repair for at least 2-3 hours to allow the material to set. 
• Use a toothbrush to gently clear any excess material from around the crown, cap, or inlay.

Customer Reviews