Alcor Scientific Sentinel Enteral Feeding Pump

How to operate the Sentinel Plus Enternal Feeding Pump?

Programming The Pump -

• Turning The Pump On -
  Press the Green On button. Alarm sounds brief and displays flash all 8's
• Set Infusion Rate -
  Press the UP or DOWN button until desired infusion rate is displayed
• Set Dose Limit -
  To set the dose limit, press SET then press UP or DOWN until the desired dose is displayed. Note - If dose limit is not set (display = 0), the pump will run until container is empty or the pump is stopped
• Begin Feeding -
  Open roller clamp, press RUN/STOP to begin feeding
• Changing the Infusion Rate -
  - To change the infusion rate, press RUN/STOP to stop the pump
  - Press UP or DOWN to make the necessary adjustment
  - Press RUN/STOP to resume
  - The infusion rate is retained in the memory
  - Note - If UP or DOWN is pressed without stopping the pump, an alarm will sound and the pump will continue running and there will be no change in infusion rate.
• Viewing Total Accumulated Volume -
  - To view the total accumulated volume delivered, press DOSE CHECK
  - Note - If pressed while running, the pump will stop momentarily
• Adjusting Display Brightness -
  Press/hold UP and SET simultaneously to change bright or dim
• Locking/Unlocking Keypad -
  To lock/unlock the keypad, while pumping, press/hold UP and DOWN simultaneously
• Turning Pump Off -
  To turn the pump off at any time, press the red OFF button
• Clearing Pump Setting -
  - To clear pump settings, press RUN/STOP to stop the pump
  -Note - If CLEAR is pressed while the pump is operating, the alarm will sound and the pump will continue operation. Settings will remain unchanged.
• Resetting Volume Delivered -
  To reset Volume Delivered to 0 - Press and hold CLEAR, the pump beeps once, pauses beeps twice and the volume clears to 0
• Resetting Dose Limit -
  To reset the Dose Limit to 0 - Press SET then presses and hold CLEAR within 3 seconds. The pump will beep once, pause, beep twice, and display clears to 0
• Resetting Total Accumulated Volume Delivered -
  To reset total accumulated volume delivered to 0 - Press DOSE CHECK, then press and hold CLEAR within 3 seconds. The pump will beep once, pause, beep twice, and the display clears to 0
• Clearing Volume Delivered, Dose Limit, and Resetting Infusion rate to 5 -
  To clear Volume Delivered, Dose Limit and reset Infusion Rate to 5 -Press and hold CLEAR for 7 beeps total (approx. 10 seconds)

How to Clean the Pump?

• With warm, soapy, water dampen a cloth or sponge
• Clean the pump housing and rotor
• Clean the drop sensor with soft cotton swabs dipped in isopropyl alcohol

A Guide To Sentinel Enteral Feeding Pump -

• What are the minimum and maximum flow rates?
  - 5-295mL/hr in 1 mL increments
• What is the weight and size of the pump?
  - 1.42kg (3.13lbs), 15cm H x 20cm W x 9cm D (5.91in H x 7.87in W x 3.54in D)
• What kind of administration sets can I use with the SENTINEL?
  - Use only SENTINEL administration sets. Use of ente

Specification

Customer Reviews